factor

 


 
 
 
 User Commands                                           factor(1)
 
 
 


NAME

factor - obtain the prime factors of a number

SYNOPSIS

factor [ integer ]

DESCRIPTION

factor writes to standard input all prime factors for any positive integer less than or equal to 10**14. The prime factors are written the proper number of times. If factor is used without an argument, it waits for an integer to be entered. After entry of the integer, it fac- tors it, writes its prime factors the proper number of times, and then waits for another integer. factor exits if a 0 or any non-numeric character is entered. If factor is invoked with an argument (integer), it writes the integer, factors it and writes all the prime factors as described above, and then exits. If the argument is 0 or non-numeric, factor writes a 0 and then exits. The maximum time to factor an integer is proportional to sqrt(n), where n is the integer which is entered. factor will take this time when n is prime or the square of a prime.

OPERANDS

integer Any positive integer less than or equal to 10**14. EXIT STATUS 0 Successful completion. 1 An error occurred.

DIAGNOSTICS

factor prints the error message Ouch! for input out of range or for garbage input.

ATTRIBUTES

See attributes(5) for descriptions of the following attri- butes: ____________________________________________________________ | ATTRIBUTE TYPE | ATTRIBUTE VALUE | |_____________________________|_____________________________| | Availability | SUNWesu | |_____________________________|_____________________________| SunOS 5.8 Last change: 31 Jan 1996 1 User Commands factor(1)

SEE ALSO

attributes(5) SunOS 5.8 Last change: 31 Jan 1996 2