ENDCTLRCY (End Controller Recovery)

ENDCTLRCY Command syntax diagram

 

Purpose

The End Controller Recovery (ENDCTLRCY) command ends error recovery procedures for a specific controller. If any type of failure occurs after this command is run, an inquiry message is sent.

Use the Resume Controller Recovery (RSMCTLRCY) command to reestablish error recovery procedures for the controller.

 

Required Parameters

CTL

Specifies the controller whose recovery is ended. Specify the name of the controller in the controller description.

Example for ENDCTLRCY

ENDCTLRCY  CTL(TROLL3)

This command ends error recovery procedures for the controller TROLL3.

Error messages for ENDCTLRCY

*ESCAPE Messages

CPF2703

Controller description &1 not found.

CPF5924

Controller &1 does not allow automatic error recovery.

CPF5928

Controller &1 not varied on.

CPF5929

Controller &1 assigned to another job.

CPF5935

Error occurred during command processing.

CPF5936

Not authorized to controller &1.