Troubleshooting CHINIT statistics data
Checks to carry out if CHINIT statistics SMF data is not being produced.
Procedure
- Issue the display trace command. You need TRACE(S) CLASS(4) enabled for information about the CHINIT.
-
If the trace is enabled, SMF data is written:
- On a timed interval - depending on the value of the STATIME system parameter. A value of zero means that the SMF statistics broadcast is used. Use the DIS SYSTEM command to display the value of STATIME.
- If the SET SYSTEM command is issued to change the value of the STATIME system parameter.
- When the CHINIT is shut down.
- If the STOP TRACE(S) CLASS(4) is issued, any statistics data is written out.
- SMF can hold the data in memory before writing it out to the SMF data sets or the SMF structure. Issue the MVS command D SMF,O and note the MAXDORM value. SMF can keep the data in memory for the MAXDORM period before writing it out.